Pensky Martene Flash Point Apparatus

Home Petroleum Testing Products Pensky Martene Flash Point Apparatus
cryostat-bath

Test Method

Flash Point is lowest temperature at which application of the ignition source causes the Vapour of a specimen of the sample to ignite under the specified condition of the test. The temperature of the approximately 70 ml test specimen is increased rapidly at first and then at a slower constant rate as the flash point is approached. At specified intervals a test flame is passed across the cup, to measure the tendency of the test specimen to form a flammable mixture with air under controlled laboratory conditions.

Standard

Conforms to the specifications of: ASTM D93; IP 34; ISO 2719

Manual

  • Temperature .Range: 79 to 400°C.
  • Test Method : ISO 2719, ASTM D 93, IP 34, IS 1448 (P-21).
  • Ignition Source : Crank Mechanism spring loaded with manual handling.
  • Temperature Sensor : Thermometer .
  • Flash/Fire Detector: Manual / Visual flash detection.
  • BController: Energy regulator manual type.
  • Flame-Sampling Arrangement: By Hand.
  • Heater: 800 W, 230 v.
Read more

Semi Automatic PMCC

  • It determines the flash point by semi-automatic Pensky Martene closed cup tester of fuel oils, lube oils, suspension of solids, liquids that tend to form a surface film under test conditions, and other liquids.
  • Hi-Tech 30C Semiautomatic Pensky Martene flash point apparatus electrically heated can be controlled by energy regulator or voltage variac.
  • It can be heated electrically or by gas also.
  • Dual speed - Deluxe model.
  • With oil cup, lid, gas ignition device.
  • Electric driven stirring device with dual speed 90-120 rpm and 250 rpm.
  • Air arrangement for cooling.
  • Energy regulator temperature controller with temperature indicator.
  • Gas ON/OFF valve.

Automatic PMCC

  • Single Action Setting: - The Flash Detection sensor and temperature sensor are permanently mounted on a lid, which allows easy setting of the specimen. Easy Operation: - Select a Test Mode and enter the expected flash Point. While instrument executes the test, you are free to do other lab work. The tester follows the exact procedures prescribed in the test method and the completion of the test cycle is signalled by buzzer. The test result is brightly shown in VFD and same will be stored in the HMI.
  • Temp. Range: 79 to 400° deg C.
  • Test Method: ISO 2719, ASTM D 93, IP 34, IS 1448 (P-21).
  • Ignition Source: Electrical ignitor with LPG gas connection.
  • Temperature Sensor: PT-100 in stainless steel sheath.
Read more


Get Quote